Three different dresses, one necklace. My girls were just flower girls in both of their aunt's weddings and with Christmas coming up, there are a lot of new dresses in their future. They needed necklaces to wear with all three dresses, but instead of making three different necklaces, I went with a simple and gorgeous necklace that would match all three. I love how these pearl bubble necklaces turned out and they really do go with just about everything!
I got everything I needed for this necklace from Fizzy Pops!
You will need from Fizzy Pops:
- 20 MM Faux Pearl White Beads (2 Packs per necklace)
- Large White Flowers 35 mm
- Daisy Flower Spacers
- 6mm jump rings
- lobster clasps
- crimp beads
- beading wire
Close a 6mm jump ring and slide it on the end of your wire. Loop the wire around the ring and then slide two crimp beads over both sections of wire. Use a pair of pliers to crimp the crimp beads down until they are tight and flat. You can also add an extender chain at this point, if you want to. For detailed instructions on adding an extender chain, check out the Fizzy Pops tutorial here.
After your beads are crimped. you are ready to add your necklace beads.
Slide a lobster clasp onto a 6mm jump ring and then close the jump ring. Slide the jump ring onto the wire and then double back the wire through the crimp beads and a couple extra of the necklace beads. Crimp the crimp beads until they are tight and then trim the excess wire.
If you want the rose pendent to hang directly in the center, instead of to the side, use the same amount of beads on each side of the necklace, instead of a few more on one side. You can also make this necklace a straight pearl necklace by omitting the flower pendent.
Fizzy Pops has generously offered to give on lucky reader the supplies to make their own pearl necklace, like the ones my daughters are wearing in the photos!
Contest is open to the USA, enter using the Rafflecopter below?
a Rafflecopter giveaway
Who would you make a necklace for?